Our parallel superimposed single/bipolar fully inverted pulse power system is the first of its kind in China (Note: Our fifth generation parallel superimposed fully inverted power supply has been in use for 3 years, and we have parallel production lines in Xi'an, Hunan and Jiangsu.)

Main features of our micro-arc oxidation line

The power supply is dedicated to the surface micro-arc oxidation treatment of aluminum, magnesium, titanium and alloy materials. At the same time, the power supply can be used in parallel and can be split, with low equipment failure rate (the IGBT and charging and discharging capacitors have small single machine currents, so it is not easy to fry or break circuit during start-up and stopping), low energy consumption (more than 10% less than single machine energy consumption), easy to parallelize, maintain and repair. 

(1) Significantly reduce the power consumption: the output power is started in stages, the internal consumption of the system is low; the current of small power devices rises quickly; the power factor is high, the operating cost is low, and the level of power consumption under the same peak current is reduced to about 40% of the traditional;.

(2) All the basic output units of the new power supply can be output in both forward and reverse directions to form a bipolar pulse power supply with adjustable ratio.

(3) With the increase of production capacity, it is easy to expand the production capacity by adding more unit modules later.

- Control mode: Touch screen + PLC control, with manual control, near-ground control, and remote communication control functions.

- Display: output voltage, current value, frequency, duty cycle, fault display, real time observation of the process curve

- Operating mode: constant voltage, constant current 

- Input voltage: three-phase four-wire ~ 380V 50HZ Input capacity: not less than 70KVA/table

- Output voltage: pulse voltage 80-750V, output current: output pulse current 0-2500A continuously adjustable, maximum average current 100A/table; in parallel = 100*N.

- Pulse frequency: 100~2000HZ continuously adjustable Pulse width: 50-500us continuously adjustable; Duty cycle: 5-80% continuously adjustable; Working time: 0-999 minutes of micro-arc oxidation processing time continuously adjustable; Alarm prompt for finishing treatment

- Power cooling mode: power devices inside the power supply using water cooling or air cooling mode

- Regulation mode: constant voltage, constant current, constant power

- Other: The power supply system is easy to operate, easy to set and modify process parameters, intuitive display, multiple protection and audible and visual alarm functions for over-current, over-voltage, short-circuit, phase failure, over-heat, etc.; with printing function.

- Warranty One year warranty  

- Main functions: The power supply are designed and produced with high-power imported IGBT, full switch inverse circuit.

- 1. The master controller is designed and programmed by DSP digital chip to realize color touch screen display and operation, freely realize control of downstream power supply, one master controller can control up to 8 power supplies at the same time; 2.

- 2. the controlled power supplies have independent display and control system (can be run independently), color touch screen operation, and choose to accept the control and operation of the master controller.

- 3. the controlled power supply: air-cooled, with a temperature-sensitive probe to prevent temperature difference The controlled power supply: air-cooled, with a temperature-sensitive probe to prevent excessive temperature difference

- 4. the controlled power supply adopts high-frequency inverse mode of operation, the output stage adopts high-frequency inverse mode of operation, and the output stage uses high-power IGBT tubes as chopper tubes.

- 5. the size of the combined cabinet: 2000 high, 900 wide, 900 deep (actual delivery size shall prevail) 6.

- 6. the controlled power supply can also be combined (parallel) with multiple units, total power = single power * number of units.

- 7. RS485

Model: 30A, 100A two. The model number is based on the average current of the positive phase output, where the output current is divided by 2-5A to represent the processing volume of each batch.